| Type of Material: | Thesis |
| Title: | A chip-tool interface lubrication technique for improvement in machinability of en-31 steel |
| Researcher: | Laxman Baburao Abhang |
| Guide: | Hameedullah, M |
| Department: | Department of Mechanical Engineering |
| Publisher: | Aligarh Muslim University |
| Place: | Aligarh |
| Year: | 2012 |
| Language: | Arabic |
| Subject: | Mechanical engineering | Lubrication technique | Calibration | Mechanical engineering |
| Dissertation/Thesis Note: | PhD |
| Fulltext: | Shodhganga |
| 000 | 00000ntm a2200000ua 4500 | |
| 001 | 262868 | |
| 003 | IN-AhILN | |
| 005 | 2019-05-29 01:42:12 | |
| 008 | __ | 150518t2012||||ii#||||g|m||||||||||ara|| |
| 035 | __ | |a(IN-AhILN)th_262868 |
| 040 | __ | |aAMUL_202002|dIN-AhILN |
| 041 | __ | |aara |
| 100 | __ | |aLaxman Baburao Abhang|eResearcher |
| 110 | __ | |aDepartment of Mechanical Engineering|bAligarh Muslim University|dAligarh |
| 245 | __ | |aA chip-tool interface lubrication technique for improvement in machinability of en-31 steel |
| 260 | __ | |aAligarh|bAligarh Muslim University|c2012 |
| 502 | __ | |bPhD |
| 518 | __ | |oDate of Notification|d2012 |
| 520 | __ | |aMachinability of a material provides an indication of its adaptability to a machining process. In general, machinability is defined as ease of machining of a material, characterized by low cutting force, high material removal rate, good surface finish,^ |
| 650 | __ | |aMechanical engineering|2UGC |
| 653 | __ | |aMechanical engineering |
| 653 | __ | |aLubrication technique |
| 653 | __ | |aCalibration |
| 700 | __ | |aHameedullah, M|eGuide |
| 856 | __ | |uhttp://shodhganga.inflibnet.ac.in/handle/10603/11279|yShodhganga |
| 905 | __ | |anotification |
User Feedback Comes Under This section.